[Xterra Mike]

Welcome. the kit is a good kit. you need a pulley puller for your crank pulley. you can get one from an auto parts store. Take the radiator out to give yourself more room in there. If you see anything that might be going bad just replace it while your in there. (hose, rusty nut) One very important tip. When pulling the pulley take the bolt all the way out with a impact gun (thats the only way your getting that thing off) remove the washer from the bolt and thread the bolt back in maybe 1/4 inch. pull the pulley off but if it starts getting tight stop turning. take the puller off and back out the bolt. you should never feel the puller getting harder to turn. If so you are actually pullin the pulley against the bolt and you will chip a piece off the pulley. Good luck